PAINTS - Indoor paints - ALFA indoor dispersion wall paint
Indoor
Can be applied with cotton roller
Can be applied with paint brush
Can be applied with airless spray gun
Can be thinned with water
Packaging
Pallet
Packaging
Pallet
ALFA indoor dispersion wall paint
The REVCO ALFA is
- high quality indoor dispersion wall paint,
- premixed in the factory,
- having a mat appearance.
Available colours: Colours Ni. 1 and 2 of the VARIO colour chart.
The ALFA indoor dispersion wall paints are suitable for coating indoor plastered, filled, concrete, gypsum, plasterboard, asbestos cement and brick surfaces of new and old buildings. Its coating is aesthetic, it can be cleaned easily. It does not hinder the natural ventilation of the wall.
The substrate shall be free from dust and dirt, and the full layer thickness shall be dry. In case of plastered surface and concrete wall the substrate shall be load bearing, as well as free from movement and shrinkage. Repair the substrate defects, use overlapping strengthening bands at the crack and at the joints of plasterboards and dissimilar materials.
It is necessary to use REVCO PRIMER wall impregnating agent before applying paint on absorbent substrate (such as old plastering, porous concrete, repaired base plastering). Remove dust caused by previous operation or by other reason from the surface. Agitate the wall paint before starting the application by means of blades attached to slowly revolving drilling machine.
Required quantity: ~10 m2/l/layer is recommended with thinning in one layer.
The hiding power of EXTERIOR outdoor wall paint depends on the substrate, it is recommended to use two layers among normal conditions. The specified quantities refer to smooth substrate. The quantity required for rough surfaces should be checked on site. We cannot assume responsibility regarding the required quantities.
Thinning: maximum 5%
Colouring: in limited number of colours of the VARIO colour chart.
Application: Tools: brush, roller or spray gun
Spreading: Apply uniformly and smooth it in multiple directions.
Temperature: The temperature of air and wall surface shall be between +5 °C and +25 °C.
Dust dry: 2.0 h
The specified values are valid at a temperature of 20 °C and a relative humidity of 42 %. The application and drying times may be significantly longer if the weather changes (low temperature, high humidity content).
Hiding power: Class II, MSZ En 6504/3
Surface: mat
Recommended number of layers: minimum 2
Overcoating interval: min. 12 h
Cleaning: With wet cloth
Storing: In original packaging at a place free from freezing. Can be stored for 18 months after production. (date of production is on the edge of the bucket) Carefully close the bucket after using.
Density (at 20°C): 1.55 g/cm3
Non volatile part: ~60 % (m/m) (at 105 °C, 3 h)
Packaging: 2.5 l, 10 l, 15 l
Permit: TÜV KERMI E-307560
While drying, the agent must be protected from direct sunlight, draught, frost, driving rain, and temperatures above 30°C. Please refer to the label on the bucket and the technical information for the agent before application. Our technical specification is based on the premise that our products are used by trained professionals. The product and the information leaflet have been produced on the basis of our latest experience and knowledge, but this does not exempt the user from carrying out preliminary practical tests and colour checks. After starting the application, no complaints with respect to colour shall be accepted.
The colours on the sample materials are for information only; due to the differences in application and weather conditions, a complete colour match cannot be guaranteed.
Avoid contact with skin and eyes; in case of contact, rinse thoroughly with water and consult a doctor if necessary.
