GLAZES - Primers - Wood Line Wood protecting primer

Can be applied with microfiber roller
Can be applied with paint brush
Can be applied with air spray gun

Wood Line Wood protecting primer

  • An outdoor primer,
  • premixed in the factory,
  • contains water based resinand property improving additives,
  • provides outstanding protection against grey mould,
  • blue fungus and insects,
  • high quality,
  • clear,
  • which has to be applied before using REVCO WOOD-LINE wood glaze.

The WOOD-LINE primer is suitable for priming new outdoor wood (railing, fence, furniture, window, doors, etc.) surfaces. It enhances the graining and pattern of the wood, and provides protection against weather conditions. The useful life of outdoor wood surfaces is extended by its use.

The substrate shall be free from dust and dirt and the entire layer thickness shall be dry. Repair the surface defects, unevenness, drying fissures before starting the application of glaze in harmony with the material and homogeneity (colour) of the substrate. Remove entire layer of earlier varnish from the surface by means of polishing before applying the glaze. Discolouring may occur during the application of glaze in case of certain kinds of tropical wood and if the material is not dry enough. You are reminded that each wood (within the same species too) has different absorbing ability.

One layer of WOOD-LINE primer should be used in every case of outdoor use. Shake or agitate the primer before starting the application. Shake the material from time to time during the work.

The required quantity of Wood Line primer depends on the humidity absorbing ability of the substrate, as wells on the mode of application. Application  in one layer is recommended.

Required quantity:
10 - 12 m2/l
Perform a fine polishing after applying the primer, as well as after the first layer of glaze if necessary.

Thinning: Not necessary.

Premixed in the factory in 24 colour shades.Temperature: The temperature of air and wall surface shall be between +5 °C and +25 °C. Do not apply the materials in extreme weather conditions, such as strong sunshine, during rain, at freezing temperatures and during strong wind, because such conditions could lead to cracks during drying and application periods.

Total drying time: 3 h
The specified values are valid at a temperature of 20 °C and a relative humidity of 42 %. The application and drying times may be significantly longer if the weather changes (low temperature, high humidity content).

Overcoating interval: min 12 h.

It can be cleaned with tap water and soft bristle brush. Avoid the use of cleaning and scrubbing agent containing strong chemicals. Wash the tools and drops immediately after application of the paint.

One year in original packaging at a place free from freezing. Carefully close the box after using. The formation of skin on the surface can be reduced by turning the box upside down before storing.

Packaging: 5 l, 1 l

Fire hazard class: Not flammable. Belongs to fire hazard class E

Affected by frost!

While drying, the agent must be protected from direct sunlight, draught, frost, driving rain, and temperatures above 30°C. Please refer to the label on the bucket and the technical information for the agent before application. Our technical specification is based on the premise that our products are used by trained professionals. The product and the information leaflet have been produced on the basis of our latest experience and knowledge, but this does not exempt the user from carrying out preliminary practical tests and colour checks. After starting the application, no complaints with respect to colour shall be accepted.

The colours on the sample materials are for information only; due to the differences in application and weather conditions, a complete colour match cannot be guaranteed.

Avoid contact with skin and eyes; in case of contact, rinse thoroughly with water and consult a doctor if necessary.

Related documents



Wall paints, glazes, plasters, supplementary items and thermal insulations systems ...